Universal Fit Band Saw Motor Kit
1.34 HP 1,000 Watt Computer Controlled Servo Motor.
Best for up to 10" Band Saws.
Includes stand alone Driver with stick anywhere rotary speed control switch.This allows placement of the control in a safer location wile placing the run/stop speed control in an easy access location.
Universal Mount:
Makes fitting the motor to multible saws possible with just nuts and bolts.
See images for measurements.
Comes standard with AK20 that is a 2.0 OD 1/2 inch wide pulley.
Contact us before you order as we need to calculate blade speed for the
types of metsl and wood that you intend to cut.
if you want to fit other types of drives:
We have US version, Metric version, Toothed version, Multi Rib version and Custom made available.
Toothed or multi Rib add $10 for certian sizes, others are higher.
Custom made can be costly. Anywhere form $10 to $200
Maximum distance between control unit and motor is 28 inches.
Runs on typical 110 to 120 volt AC household power supply's
Motor programming + spindle speeds and Reverse:
- The motor speed can be programmed to operate in any range chosen by the user.
Between 300 and 3,500 RPM's.
Note: Settings are limited to 100 RPM intervals.That means it can be set to 500 RPM but it cannot be set to 550 RPM as the next step is 600 RPM- The full range of speed (RPM's) can also be controlled with just the speed control knob.
- Speed control programming only requires a few easy steps.
- Reverse is simple, just hold the yellow button for a few seconds.
- Programming includes the ability to set bottom and top RPM range separately. In other words you can program
the system to run the spindle at any speed or range of speeds you choose (see below).
Slowest speed achievable: Motor 100 RPM. (Below 300 is not recommended).
Highest speed: 3,500 RPM.- Soft start is programmable and will be set as soft as possible when you receive this motor. This program is very effective in reducing drive belt wear etc.
- Braking strength is also programmable and will be set as low as possible. Personally I wish I could set it lower.
- Self diagnostics with fault code chart and programming instructions.
- Safe turn on system where the speed control knob must be in the full counter clockwise (stop) position when turnedon. When turned on the self diagnostic system checks for faults and will not allow the motor to run until the speed control knob is turned all the way to stop first.
- Use at your own risk. Our liability is limited to the purchase price of this item.
1,000 Watt Band Saw Universal Fit Servo Motor Upgrade Kit
Motor Specifications:
- Watt: 1,000 (1.3410220888 HP
- )Voltage: 110 ~ 130 Volts AC single phase
- HZ: 60
- Torque: 12 N.M.
- RPM: 100 to 3,500 RPM in 100 RPM increments.
Note: Manufacturer recommended 500 to 3,000 RPMs My personal testing results: New item not yet tested on my machines..