top of page
1500W Servo Motor & Driver. 2HP 16 NM Torque 300~3,500 RPM
2 HP 1,500 Watt Computer Controlled Servo Motor.
Stand alone controler includes built in rotary speed control switch.

Clearance Item . No Returns

This is our base model. This motor has been replaced by our 2023 model
It now comes with a truly flat face plate and 4 M8 button head screws.
This makes face mounting to random machinery much easier. That or make your own side mount.
New in box.
 
Sold with a custom built matching control unit.
Speed is programmable for any range between 200 to 3,500 RPM
Note: Settings are limited to 100 RPM intervals.

See images for measurements.
Note: the maximum distance between control unit and motor is 28 inches.

Runs on typical 110 to 120 volt AC household power supply's
 
Motor programming + spindle speeds and Reverse:
  • The motor speed can be programmed to operate in any range chosen by the user.
    Between 300 and 3,500 RPM's.
    Note: Settings are limited to 100 RPM intervals.That means it can be set to 500 RPM but it cannot be set to 550 RPM as the next step is 600 RPM
  • The full range of speed (RPM's) can also be controlled with just the speed control knob.
  • Speed control programming only requires a few easy steps.
  • Reverse is simple, just hold the yellow button for a few seconds.
  • Programming includes the ability to set bottom and top RPM range separately. In other words you can program
    the system to run the spindle at any speed or range of speeds you choose (see below).
    Slowest speed achievable: Motor 100 RPM. (Below 300 is not recommended).
    Highest speed: 3,500 RPM.
  • Soft start is programmable and will be set as soft as possible when you receive this motor. This program is very effective in reducing drive belt wear etc.
  • Braking strength is also programmable and will be set as low as possible. Personally I wish I could set it lower.
  • Self diagnostics with fault code chart and programming instructions.
  • Safe turn on system where the speed control knob must be in the full counter clockwise (stop) position when turned on. When turned on the self diagnostic system checks for faults and will not allow the motor to run until the speed control knob is turned all the way to stop first.
  • Use at your own risk. Our liability is limited to the purchase price of this item.

1500W Servo Motor & Driver. 2HP 16 NM Torque 300~3,500 RPM

$250.00Price
Excluding Sales Tax
  • Motor Specifications:
    • Watt:           1500  (2 HP)
    • Voltage:      110V
    • HZ:             60
    • Torque:      16 N.M.
    • RPM:         100 to 3,500 RPM in 100 RPM increments.
                         Note: Manufacturer recommended 500 to 3,000 RPMs
                         My personal testing results: This motor runs best between 300 and 3,500 RPMs.
bottom of page