top of page

New High Performance 550W servo motor for Emco Unimat 3 lathe.
Variable Speed Spindle Drive Motor Upgrade with reverse.
Fits Emco 3 Lathe. See images.

Now comes with our 2024 controler.
See image that states what comes in the box.

Motor RPM Range: 200 to 4,500 RPM
Ratio is: 1.61 motor to 1.0 Spindle.
Resulting spindle speed: 63 to 2,790 RPM

Superior torque output.

See video.
Video is assembly instructions:
See video in images above or video link below.

Contact us before you order.
You must watch the video before you purchase. This is instructions on how to make it work.

UP to 5 days lead time.

See image 2 for what is included:
Only what you see in the image without the lathe is what is included. All other images are for information only.The lathe itself is not included

Runs on typical 110 to 120 volt AC household power supply's.

Motor programming + spindle speeds and Reverse:

  • The motor speed can be programmed to operate in any range chosen by the user.
    Between 200 and 4,500 RPM's.
  • The full range of speed (RPM's) can also be controlled with just the speed control knob.
  • Speed control programming only requires a few easy steps.
  • Reverse is simple, just hold the yellow button for a few seconds.
  • Programming includes the ability to set bottom and top RPM range separately. In other words you can program the system to run the spindle at any speed or range of speeds you choose (see below).
    Slowest speed achievable: Motor 200 RPM. (Below 300 is not recommended).
    Highest speed: 4,500 RPM.
  • Soft start is programmable and will be set as soft as possible when you receive this motor. This program is very effective in reducing drive belt wear etc.
  • Braking strength is also programmable and will be set as low as possible. Personally I wish I could set it lower.
  • Self diagnostics with fault code chart and programming instructions are available on our web site.
  • Power went out safe program.
  • Use at your own risk. Our liability is limited to the purchase price of this item.

    Emco Unimat 3 Variable Speed 550 Watt Spindle Motor Upgrade with reverse

    Excluding Sales Tax
    • Motor Specifications:

      • 550W servo motor.
      • 4 NM torque.
      • 200 ~ 4,500 RPM's.
    bottom of page