Grizzly 4000 2 HP Servor motor conversion/upgrade kit.
2.0 HP 1,500 Watt Computer Controlled Servo Motor.
Includes stand alone Driver with stick anywhere rotary speed control switch.This allows placement of the control in a safer location wile placing the run/stop speed control in an easy access location.
Welded Motor Mount:
Makes fitting our motor to a Grizzly G-4,000 possible with just nuts and bolts.
Allows for horazontal adjustment to align belt.
Allows for 1" vertical travel to tighten belt.
See images for measurements.
Comes with 12L050 and 20L050 toothed pulleys and matching belt.
These timing pulleys are custom made to fit our motor to a Grizzly G-4,000 Also includes a spacer so that the 20L050 can be fit to the original spindle pulleys location.
if you want to fit other types of drives:
We have US version, Metric version, Toothed version, Multi Rib version and Custom made available.
Cost depends on dificulty and possibility of additional sales to others owning the same machine.
Maximum distance between control unit and motor is 28 inches.
Runs on typical 110 to 120 volt AC household power supply's
Motor programming + spindle speeds and Reverse:
- The motor speed can be programmed to operate in any range chosen by the user.
Between 300 and 3,000 RPM's.
Note: Settings are limited to 10 RPM intervals.- The full range of speed (RPM's) can also be controlled with just the speed control knob.
- Speed control programming only requires a few easy steps.
- Reverse is simple, just hold the yellow button for a few seconds.
- Programming includes the ability to set bottom and top RPM range separately. In other words you can program the system to run the spindle at any speed or range of speeds you choose (see below).
Slowest speed achievable: Motor 200 RPM. (Below 300 is not recommended).
Highest speed: 3,000 RPM.- Soft start is programmable and will be set as soft as possible when you receive this motor. This program is very effective in reducing drive belt wear etc.
- Braking strength is also programmable and will be set as low as possible. Personally I wish I could set it lower.
- Self diagnostics with fault code chart and programming instructions are available on our web site.
- Safe turn on system where the speed control knob must be in the full counter clockwise (stop) position when turned on. When turned on the self diagnostic system checks for faults and will not allow the motor to run until the speed control knob is turned all the way to stop first.
- Remote stop/start without self diognostics step above is possible. This is a use at your own risk
function made possible for those wishing to instal a trigger, travel or CNC switch.- Use at your own risk. Our liability is limited to the purchase price of this item.
Grizzly G 4,000 Two HP servo Motor Upgrade
Motor Specifications:
- Watt: 1,500 watt (2.0 HP)
- Voltage: 110 ~ 130 Volts AC single phase
- HZ: 60
- Torque: 16 N.M.
- RPM: 300 to 3,000 RPM in 10 RPM increments.
Note: Manufacturer recommended 500 to 3,000 RPMs My personal testing results: New item not yet tested on my machines..