top of page

Face Mount 1.0 HP 7500 Watt Computer Controlled Servo Motor.
With internal rotary speed control switch and truley flat face
and multi bolt circle.

This 2024 model includes our custom made face mount with fully machined face and multi position 
M8 X 1.25 button head mounting screws
as seen in image 1.

New in box with:

  • Internal 10 RPM incrament rotary speed control.
  • Adjustable Brake.
  • Adjustable Soft Start.
  • Adjustable revererse to include reverse on the fly.
  • Adjustable e-Stop system.
  • Programable upper limit.
  • Programable lower limit.


Soldd with a custom built 2024 control unit.
See Video.

Speed is programmable for any range between 300 to 4,500 RPM
Note: Settings alow 10 RPM intervals.

See images for measurements.
Note: the maximum distance between control unit and motor is 28 inches.

Runs on typical 110 to 120 volt AC household power supply's


Motor programming + spindle speeds and Reverse:
  • The motor speed can be programmed to operate in any range chosen by the user.
    Between 300 and 4,500 RPM's.
    Note: Settings are limited to 100 RPM intervals. That means it can be set to 500 RPM but it cannot be set to 550 RPM as the next step is 600 RPM
  • The full range of speed (RPM's) can also be controlled with just the external speed control switch.
  • Speed control programming only requires a few easy steps.
  • Reverse is simple, just hold the yellow button for a few seconds.
  • Programming includes the ability to set bottom and top RPM range separately. In other words you can program
    the system to run the spindle at any speed or range of speeds you choose (see below).
    Slowest speed achievable: Motor 100 RPM. (Below 300 is not recommended).
    Highest speed: 3,500 RPM.
  • Soft start is programmable and will be set as soft as possible when you receive this motor. This program is very effective in reducing drive belt wear etc.
  • Braking strength is also programmable and will be set as low as possible. Personally I wish I could set it lower.
  • Self diagnostics with fault code chart and programming instructions.
  • Safe turn on system where the speed control knob must be in the full counter clockwise (stop) position when turned on. When turned on the self diagnostic system checks for faults and will not allow the motor to run until the speed control knob is turned all the way to stop first.
  • Use at your own risk. Our liability is limited to the purchase price of this item.

750 Watt Face Mount Servo Motor Internal 1.0HP 10 NM torque

Excluding Sales Tax
  • Motor Specifications:
    • Watt:           750  (1.0 HP)
    • Voltage:      110 ~ 130 Volts AC single phase
    • HZ:             60
    • Torque:      10 N.M.
    • RPM:         100 to 4,500 RPM in 10 RPM increments.

    Note: Manufacturer recommended 500 to 4,000 RPMs
    My personal testing results: Runs best from 300 to 4,500 RPM's. Speeds under 300 RPM will lose torque. Heavy load and low RPMs restricts fan speed so extra cooling on motor such as heat sinks could be required.

bottom of page