Sherline Mini Lathe Servo Motor upgrade Kit.
550W motor + 2026 controller.

Lathe not included. See image 2 for what is in the box

Details:
See images and video.
Make note: Video is only valid for RPM results.
Assembly and parts included has changed. Too many requests has resulted in
this item being listed before the video is complete.
 
Runs on typical 110 to 120 volt AC household power supply's.

Comes fully programed (plug and Play)
 
Motor programming + spindle speeds and Reverse:
The motor speed can be programmed to operate in any range chosen by the user.
Between 200 and 4,500 RPM's.
Note: Settings are limited to 10 RPM intervals.
The full range of speed (RPM's) can also be controlled with just the speed control knob.
Speed control programming only requires a few easy steps.
Reverse is simple, just press the blue button.
Programming includes the ability to set bottom and top RPM range separately. In other words you can program the system to run the spindle at any speed or range of speeds you choose (see below).
Slowest speed achievable: Motor 200 RPM. (Below 300 is not recommended).
Highest speed: 5,000 RPM (above 4,500 not recommended).
Soft start is programmable and likely set as soft as possible when you receive this motor. This program is very effective in reducing drive belt wear etc.
Braking strength is also programmable and likely will be set as low as possible. 
Self diagnostics with fault code chart and programming instructions available on line.
Power out safety. Speed control knob must be manually returned to zero/stop after a power failure.
P-17 is locked to our 550W motors so it cannot be accidentally set wrong and cause issues.
Use at your own risk. Our liability is limited to the purchase price of this item.
 
California Prop 65: WARNING:
Cancer and Reproductive Harm www.P65Warnings.ca.gov
AVERTISSEMENT: Cancer et Troubles de l’appareil reproducteur www.P65Warnings.ca.gov